FEATURES:

• NEW! Hybrid construction from wood and composite materials for specially reinforced fuselage and wings.
• NEW! Patented quick assembly system for wings and SFG.
• NEW! Patented quick assembly system for canopy. Especially useful for electric version, fast battery change!
• Film covering applied over a Genuine German Oracover (Ultracote) base
• Highly prefabricated, experienced builders can have air ready in under a day
• Pre-installed aileron and elevator hinges (glued and pinned)
• Easy canister installation due to open construction
• Removable wings
• One piece stabilizer
• Laser engraved motor mounting position
• Pull-Pull system for Rudder servo
• Cowl fits both gasoline and electric motors

INCLUDED HARDWARE:

• Complete air frame with all basic accessories (such as carbon fibre main undercarriage, tail-gear assembly and wing-tubes as well as fibreglass control horns and wheel pants)
• Pre-installed hinges and pre-mounted canopy
• Fuel tank and fuel tubing pre-prepared, fuel dot and breather valve
• Wheels, axels and wheel pants
• Pre-prepared pushrods with ball links
• Matching carbon spinner, 3″

REQUIRED HARDWARE:

Motor: 30-40cc or equivalent electric

Servos: 4 high torque plus throttle // Uses x1 per aileron, x1 for elevator and x1 on rudder

Also requires all the usual accessories such as transmitter, receiver, propeller, batteries, powerbox, extension leads and possibly other small accessories.

PILOT-RC RECOMMENDED HARDWARE:

• Servo arms: Pilot-Rc 1,6″ Aluminium arms

EXTENSION WIRE LENGTHS:

Throttle:
No extension required

Each aileron:
15cm
(to reach receiver direct)

Elevator:
67cm

Rudder:
Pull pull, no extension required

CENTER OF GRAVITY:

136mm
Measured back from leading edge of the wing at the fuselage.

You will find a laser engraved C.G. emblem on the inside of the fuselage, located close to the wing tube, which also shows the exact location for Center of Gravity.